Crankshaft Holding Tool Ø60mm for 2.0L TFSI EA888 Gen.3 (Starter Generator) – like T40378

This crankshaft holding tool is designed for securing the vibration damper during removal and installation of the crankshaft central bolt on VAG 2.0L TFSI EA888 Gen.3 engines equipped with a starter generator.

It provides reliable counterholding of the crankshaft, preventing rotation and reducing the risk of internal engine damage during high-torque procedures.

Compatibility

Suitable for the following engine codes (with starter generator):
CVKB, CVLA, CYMC, CYRB, CYRC, DBPA, DDWA, DEMA, DGKB, DHDA, DKNA, DKYA, DLHB, DLVA, DLVB, DMSA, DMSB, DMTA, DNTA, DPUA, DPVA

Compatible with vibration dampers featuring:
✔ Hole spacing: 60 mm (measured center-to-center, opposite holes)

Note:
For pulleys with 70 mm hole spacing, use alternative tool (Art. No. 123208, like T40379A).

Important Usage Information

Correct identification of the installed pulley variant is required, as VAG repair documentation does not always clearly specify the installed version.

VAG specifies the use of tools T40378 or T40379A (Art. No. 123208, also suitable for EA888 Gen.4 TFSI).
If the engine is equipped with a conventional alternator, a different holding tool (Art. No. 104921, like T10355) may be required.

To determine the correct holding tool, the mechanic must measure the hole spacing (center-to-center, opposite holes) on the pulley.

Technical Specifications

✔ Drive: 3/4"
✔ Application: Crankshaft central bolt service
✔ Design: Optimized geometry for improved access and stability
✔ Material: High-strength steel construction

Important Usage Information

Correct identification of the installed pulley variant is required, as VAG repair documentation does not always clearly specify the installed version.

Before selecting the tool, measure the hole spacing (center-to-center, opposite holes) on the pulley to ensure correct fitment.

Torque Reference (Example Application)

Reference vehicle: Audi A4 (8W) 2.0 TFSI, engine DKYA (2019)

Crankshaft central bolt (with lubricated seal):
✔ Manual transmission, strength class 10.9: 240 Nm + 180°
✔ Automatic transmission, strength class 8.8: 150 Nm + 90°
✔ Automatic transmission, strength class 10.9: 100 Nm + 180°

Warning: Incorrect torque application may result in crankshaft damage. Always follow manufacturer specifications.

Additional Tools Required (Not Included)

✔ Crankshaft holding tool Ø70 mm (Art. No. 123208, like T40379A) – for pulleys with 70 mm spacing

Original part numbers are for reference purposes only. This is not an OEM tool.